|  |
| |
| Item number:
CIEN9-27081675 Manufacturer no.:
546676 EAN/GTIN:
7320285466760 |
| |
|
| | |
| Holder for Locking Active holder with cig-plug. With spring stud locking. Fits for devices with original skin. This holder is to be used when you want to have your Tab Active extra securely in place and still have it easy accessable. The active holder guarantees a newly charged battery at all times. 1 A charging. Charging via pogo plug. The holder is equipped with a spring stud locking device. The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations. An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount. INSTALLATION INSTRUCTIONS: Please read all of the instructions and look at the pictures before attaching the holder. 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. Press the spring stud locking downward. 3. To remove the device from the holder: Press the spring stud locking upward. Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder. 4. The holder is in place. More information: Design | Mobile device type | Tablet/UMPC | | Type | Active holder |
|
| | |
| | | |
| Other search terms: Mobile phone holders & mounts, Mobile phone mount, Mobile phone mounting brackets, Mobile phone mount holder, Mobile phone holder support, Mobile phone holder, Mobile phone holders, Smartphone holder, Smartphone holders, Car phone holder, Car phone holders, Car phone mount, Car phone mounts, Car smartphone holder, Car smartphone holders, Charger cigarette lighter, Charger cigar lighter, Mobile device charger auto, Charger for cigarette lighter, Chargers for cigarette lighters, Charger for cigar lighter, Chargers for cigar lighter, Tablet PC holder, Tablet PC holders, Tablet PC mount, Tablet PC mounts, Tablet stand, Tablet stands, Tablet holder, Tablet holders, Tablet mount, Tablet mounts, car mobile phone holder, car phone holder, telephone holder, phone holders, phone holder, device holder, mobile device holder |
| | |
| |