Brodit 527941 holder Active holder Tablet/UMPC Black

Active holder for fixed installation

Adjustable holder. Micro USB. With tilt swivel and fly lead. Fits devices with or without skin/case, with height 140-195 mm, max thickness 25 mm.

This holder is crash tested and approved for use with device without skin/case on Brodit's headrest mount.

Measure your device/skin/case and compare with specifications. Fits for devices with/without skin/case with height 140-195 mm, max thickness 25 mm. For use with devices with Micro USB connector.

For connection inside the dashboard, no cables hanging over the interior. With fly lead, you manually connect the charging cable to the device when needed (not automatic charging when placed in holder). With tilt swivel. Tilts 20°, swivels 360°. Padded cushions for protection against sliding/scratching. Mounting plate 42x50 mm with predrilled AMPS-holes +2x3,5 mm centered holes. Connect the power cable with a 2A fuse. Professional installation recommended. Made of high grade black ABS/Acetal plastic. Made in Sweden

Crash tested:
This adjustable holder is crash tested according to standard for car seats (ECE R17). The crash test applies for a tablet that weighs 490 g. The tests have been performed on one seat with invisible headrest pins (type Volvo etc.) and one seat with visible headrest pins (type Ford etc.) in the forward and rearward directions. The adjustable holder keeps the tablet in place during all executed tests.

Important information:
Tablets should not be installed onto a car’s dashboard. They may block the view or key controls and the ProClip is designed for installation of smaller devices (phones), not for large devices (tablets). Brodit will not give any recommendations for such installations. An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets in a holder on the car’s headrest, installed onto a Brodit headrest mount.