Brodit ProClip 854985 Passive holder Mobile phone/Smartphone, Handheld mobile computer Black

ProClip The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient - always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions. INSTALLATION INSTRUCTIONS: Please read all of the instructions and look at the pictures before attaching the ProClip. This ProClip consists of two parts: Part 1: Attaching part (the smallest part) Part 2: ProClip face plate 1. Press the thin end of the enclosed gap opener into the gap under the Start button, to widen the gap. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape cover on Part 1. Press the angled edge on Part 1 into the gap next to the gap opener. 2. Press Part 1 upward/forward, so the angled edge goes all the way into the gap and hooks behind the control panel and the adhesive tape attaches. Pull out the gap opener. 3. Open up the predrilled holes in Part 2 with a screwdriver. Peel off the adhesive tape cover on Part 2. Place Part 2 onto Part 1 so the holes match and the face plate is on the right side. Attach Part 2 onto Part 1 by using the enclosed screws. Whil screwing, keep the ProClip in place using your index finger and press it forward/upward with your thumb to ensure the screw goes all the way in and the ProClip attaches correctly. 4. The ProClip is in place.