PVC type of flat cables are used mainly as trailing cable for crane installations, floor conveyer systems and shelf control units. Not suitable for outdoor use.
Installation notes
Cables reels with flat cables must be transported in standing position on the flange. A bending flexibility can be achieved on a plane surface. For this purpose, the corresponding fitting instructions should be followed.
Put the cable trolly on the guiding rail or upon carrier beam and push them together at the starting point. The distance between the bedding surface of two cable trollys must be wider than the double thickness of a cable-packet.
During the packeting performance, it must be started with the smaller cross section which lays on the bedding surface and will be builded successively so that the biggest cross section is laying on the top.
Further, be careful of a symmetrical load distribution.
In case of multicore flat cables with small cross section, smaller than 2,5 mm², is very critical due to its low tensile stress. In such case, you should add 10% reserve wire for calculation. More information: Power | Operating voltage (max) | 750 V |  | Operating voltage (min) | 450 V | | Breakdown voltage | 2500 V | Features | Product type | Low voltage cable | | Product colour | Black | | Jacket material | Polyvinyl chloride (PVC) | | Insulation material | Polyvinyl chloride (PVC) | | Conductor material | Cooper | | Number of conductors | 24 | | Conductor cross section | 1.5 mm² | | AWG wire size | 16 | | Copper index | 360 kg/km | | Temperature range (flexing) | -5 - 70 °C | | Temperature range (fixed installation) | -40 - 80 °C | | Certification | EN 50214 / DIN VDE 0283-2 tested acc. to EN 50396, EN 50395 acc. to DIN VDE 0482-332-1-2 / DIN EN 60332-1-2 / IEC 60332-1-2 Low-Voltage Directive 2014/35/EU. | Weight & dimensions | Diameter | 83 mm |
|