Formfutura EasyFil PLA - Red (2.85mm, 750 gram)

EasyFil PLA is a high-end “easy to use” impact modified PLA (Poly-Lactic Acid) type of 3D printer filament which is optimized for FFF / FDM 3D printing technology. EasyFil PLA is tougher and less rigid than standard PLA and its improved filament flowing behaviour and interlayer adhesion make EasyFil PLA an extremely easy to print filament.

Unique features
- Very easy to print
- Warp-free printing and no deformation after cooling
- Improved flowing behaviour and inter-layer adhesion
- Good first layer adhesion to several (un)heated print surfaces
- Slightly softer than standard PLA resulting in improved strength and impact resistance
- Almost odourless processing/printing
- Biodegradable
- Wide variety of vivid opaque colors

General printing guidelines *
- Nozzle size: ≥ 0.15mm
- Layer height: ≥ 0.1mm
- Flow rate: ± 100%
- Print temp: ± 180 - 220° C
- Print speed: Medium
- Retraction: Yes ± 5mm
- Heat bed: ± 0 - 60° C
- Fan speed: 50-100%
- Experience level: Beginner

*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.

Compliance *
This filament is compliant to below listed directives and regulations.
- RoHS directive 2011/65/EC
- REACH directive 1907/2006/EC

*) This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.