Brodit 721093 holder Active holder Tablet/UMPC Black

Fits for devices with original skin. With USB-cable with cig-plug adapter. With tilt swivel and USB Host. Active holder with a USB-cable with cig-plug adapter for charging of your device. You can choose to connect the cig-plug to the car's 12 Volt socket, or to remove the cig-plug adapter and connect the USB cable to the car's USB connector. Equipped with a tilt swivel so you can adjust the angle and easily switch between portrait and landscape mode. 12V. The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds. Tablets should not be installed onto a car’s dashboard if they block the view or block key controls. The ProClip is designed for installation of smaller devices e.g. smartphones, not large tablets. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.