Brodit 712183 holder Active holder Tablet/UMPC Black

Use an active holder for your Panasonic while driving and you will always have a freshly charged battery! The holder provides a neat and comfortable installation - safe and convenient. The holder is equipped with a cig-plug for connection to the vehicle's 12/24 Volt socket. 3A charging. Charging via pogo plug. Customized holder with a perfect fit for device with scanner frame and handstrap. The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position.Tilts 17° and swivels 360°. It is easy to put the device into place in the holder, and to take it with you when leaving the car. Mountingplate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Color: black. Made in Sweden. Attach onto a Pedestal Mount. Easy-switching system: The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds. (Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit will not give any recommendations for such installations.)