 | |
Range of Product: | NORVI HMI Controller |
Product Type: | Programmable HMI |
Certifications: | EN 61131-2:2007, EN 61010-1:2010+A1:2019, EN IEC 61010-2-201:2018, 2014/30/EU- Electromagnetic Compatibility (EMC), Annex III, Part B, Module C |
Rated supply voltage: | 12 - 24V DC |
Communication: | RS-485 Ethernet |
Inputs and Outputs: | 4 x Digital Inputs, 4 x Analog Inputs 4-20mA, 4 x Transistor outputs |
Displays and Visual Indicators: | LCD Display |
Product Unified Code: | ESP-HMI-5C-VI |
Product Part Numbers: | ESP-HMI-5C-VI |
Enclosure: | OP-300-B |
Mounting / Installation Method: | DIN Panel Mount / Cutout 116 x 163 mm |
Terminal Type: | SCREW TERMINAL |
Terminal Arrangement: | Top and Bottom | Digital Input 0 - IO0, Digital Input 1 - IO1, Digital Input 2 - IO2, Digital Input 3 - IO3 | A0 : Analog Input 0 - ADS1115 - 0x48 - AIN0, A1 : Analog Input 1 - ADS1115 - 0x48 - AIN1, A2 : Analog Input 2 - ADS1115 - 0x48 - AIN2, A3 : Analog Input 3 - ADS1115 - 0x48 - AIN3 | TR01 - IO4 , TR02 - IO5 , TR03 - IO6 , TR04 - IO7 |
Length: | 179.6 mm |
Height: | 129.6 mm |
Width: | 42.6 mm |
IP degree of protection: | IP20 |
Operating altitude: | 0 - 2000 meters |
Operating Temperature: | -10 - +85C (185 °F) |
Storage altitude: | 0 - 3000 meters |
Shock resistance: | 15 gn for 11ms |
Resistance to electrostatic discharge: | 4kV on contact 8kV on air |
Resistance to electromagnetic fields: | 10 V/m (80 MHz - 1GHz) , 3 V/m (1.4 MHz - 2 GHz) , 1 V/m (2 MHz - 3 GHz) |
Rated Supply Voltage (V): | 24V DC |
Current Consumption (mA): | 100mA |
Recommended Power Source: | 2W |
SOC / MCU: | ESP32-S3-WROOM32-1-N16R8 |
Flash Memory: | 16MB |
ROM: | 384 KB |
SRAM: | 512 KB |
PSRAM: | 8 MB (Octal SPI) |
Card Type: | microSD |
Interface: | SPI | I2C |
SD CARD CS: | GPIO37 |
MISO: | GPIO19 | GPIO11 |
MOSI: | GPIO12 | GPIO13 |
SCLK: | GPIO13 | GPIO12 |
SD Detect: | NOT CONNECTED |
RTC Chip: | DS3231 |
Backup Battery Type: | CR2032 |
I2C Address: | 0x68 |
SCL Pin: | GPIO19 |
SDA Pin: | GPIO20 |
Display Driver: | ER-TFT050-3 |
Display Size: | 5 inch |
HSYNC: | GPIO6 |
VSYNC: | GPIO5 |
DEN: | GPIO4 |
DCLK: | GPIO7 |
DISP CS: | GPIO39 |
R0: | Connected to GND |
R1: | Connected to GND |
R2: | Connected to GND |
R3: | GPIO1 |
R4: | GPIO41 |
R5: | GPIO40 |
R6: | GPIO38 |
R7: | GPIO45 |
G0: | Connected to GND |
G1: | Connected to GND |
G2: | GPIO48 |
G3: | GPIO47 |
G4: | GPIO21 |
G5: | GPIO14 |
G6: | GPIO9 |
G7: | GPIO3 |
B0: | Connected to GND |
B1: | Connected to GND |
B2: | Connected to GND |
B3: | GPIO8 |
B4: | GPIO18 |
B5: | GPIO17 |
B6: | GPIO16 |
B7: | GPIO15 |
Number of Digital Inputs: | 4 |
Digital Input Polarity: | Sink and Source |
Digital Input Maximum Voltage: | 32V DC |
Digital Input Minimum Voltage: | 18V DC |
Maximum Switching Frequency: | 1 kHZ | 1 kHz |
IO Connection: | Via PCA9535PW, SCL - Pin 14, SDA - Pin 15, , I2C Address - 0x73 |
Number of Analog Inputs: | 4 |
Analog Input Measurement Range: | 0-10V |
Analog Input Maximum Voltage: | 38V DC |
Analog to Digital Converter (ADC): | ADS1115 |
Analog to Digital Converter (ADC) Communication: | I2C |
Analog to Digital Converter (ADC) Address: | 0x48 |
Number of Transistor Outputs: | 4 |
Transistor Output Type: | OPEN COLLECTOR |
Maximum Sink/Source Current (mA): | 100mA |
Maximum Applicable Voltage: | 40V DC |
Communication Mode: | FULL-DUPLEX |
Transceiver: | SP490CN-L | W5500 |
Unit Load: | 1 |
TX Pin: | GPIO3 |
RX Pin: | GPIO35 |
Speed: | 10BaseT/100BaseTX |
Supports Auto Negotiation: | Yes |
TX/RX Buffer Size: | Internal 32 Kbytes Memory |
Supported Hardwired TCP/IP Protocols: | TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE |
Number of Simultaneous independent sockets: | 8 |
SCSn: | GPIO10 |
PCA9535PW PIN: | Connection |
1 - A0: | Pulled up to 3.3V |
2 - A1: | Pulled up to 3.3V |
3 - RESET: | Pulled up to 3.3V |
4 - IO0: | Digital Input 1 |
5 - IO1: | Digital Input 2 |
6 - IO2: | Digital Input 3 |
7 - IO3: | Digital Input 4 |
8 - VSS: | GND |
9 - IO4: | Transistor Output 1 |
10 - IO5: | Transistor Output 2 |
11 - IO6: | Transistor Output 3 |
12 - IO7: | Transistor Output 4 |
13 - INT: | Pulled up to 3.3V |
14 - SCL: | SCL |
15 - SDA: | SDA |
16 - VDD: | 3.3V |
Gewicht: | 0.2 kg |