Development Board Accessories (77 items)

Power over Ethernet (PoE) Switch HAT for Raspberry Pi This Power over Ethernet (PoE) Switch HAT powers your Pi board using ethernet, meaning that there is no need for a power supply.You can plug th...

Toss out those FTDI cables and go USB-native with the ATmega32u4. After many months of back-orders, we finally received a shipment of these little guys and are excited to offer our breakout board. ...

DIY ist unser Ding! Hier kannst du deine eigene Brick Welt weiterentwickeln. Dieses Set kommt mit 25 leeren Platinen, 25 Kunststoff Schalen, verschiedenen Widerständen, Steckerersatzteilen, Kondens...

The MKR THERM Shield allows a board of the MKR family to acquire temperatures from a thermocouple of type K and a DS18Bxx digital one wire sensor. The Thermocouple is a kind of temperature sensor t...

Crossover made of high-grade copper coils, MKT foil capacitors and low-loss audio frequency electrolytic capacitors, mounted on epoxy PC boards. Checked with regard to functioning, slope steepness ...

This fully-assembled pan-tilt kit is the perfect way to give your project full range motion with two micro servos. The pan-tilt can rotate roughly 180° from side-to-side and can tilt up&downwards a...

The HiFiBerry DAC+ is a high-resolution digital-to-analog converter for the Raspberry Pi 2 Model B and the A+ / B+ Models. This product also works with the Pi 3! This is a special sound card for th...

Need to connect a device to a CAN (Controller Area Network) for communication within an automobile and with other CAN devices? The Arduino MKR CAN shield will provide automotive CAN connectivity. W...

PowerBoost is the perfect power supply for your power-hungry portable project! This little DC/DC boost converter module can run from 1.8V batteries or higher, and convert that voltage to 5.2V DC fo...

DESCRIPTION Round and round and round they go! 24 ultra bright smart LED NeoPixels are arranged in a circle with 2.6" (66mm) outer diameter. The rings are 'chainable' - connect the output pin of on...

Crossover made of high-grade copper coils, MKT foil capacitors and low-loss audio frequency electrolytic capacitors, mounted on epoxy PC boards. Checked with regard to functioning, slope steepness ...

Plug this module onto your Arduino Board, connect it to your network with an RJ45 cable (not included) and follow a few simple steps to start controlling your world through the internet. As always ...

Here's a handy Arduino shield: we've had a lot of people looking for a dedicated and well-designed data logging shield. We worked hard to engineer an inexpensive but well-rounded design. Not only i...

If you are experimenting with monitoring fleets, high-altitude scientific experiments, or any kind of project requiring localization of devices, the MKR GPS Shield will offer you the functionality ...