Mounting Kits (19 items)

Contains bracket recommended for Pole MPN: SNS-201 Pole is not included.

The Capture Pole Mount kit enables you to improve your existing POS installation. Quick and easy installation allows you to fully customize your POS solution, perfectly suited for your ergonomic

This RAM-2461U-EXT1 consists of a 1.5" rubber ball, connected to a 3.625" square plate with a 75mm X 75mm VESA hole pattern. Included on the plate is a 3/8"-16 tapped hole. The rubber ball is posit...

The RAM-D-202U-23 contains a 2.25" diameter rubber ball connected to a rectangular plate with a 4-hole pattern of 1.5" x 2.5" center to center.

The RAP-B-200-2 consists of double 1" diameter open ball sockets with a 360 rotation point at the center and a connecting swivel joint that rotates forward and back 180. The rubber ball and socket ...

The RAM-201-B, short double socket arm, has a socket at both ends that accommodates 1.5" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and socket ...

The RAM-D-201U-C, short double socket arm, has a socket at both ends that accommodates 2.25" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and soc...

The RAM-201, standard length double socket arm, has a socket at both ends that accommodates 1.5" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and...

The RAM-224U consists of a 3.3" twist lock suction cup base that is connected to the (RAM-238), diamond base with 1.5" rubber ball. The suction cup is designed to have an extra strong hold on any s...

The RAM-B-202 consists of a 1" diameter rubber ball connected to a flat 2.5" diameter base. This mount has pre-drilled holes, including the universal AMPs hole pattern.

The RAM-202 consists of a 1.5" diameter rubber ball connected to a flat 2.5" diameter base. This mount has pre-drilled holes, including the universal AMPS hole pattern.

The RAM-D-246U-IN1 consists of a 2.25" rubber ball, connected to a 4.75" square plate with 4x100mm holes and 4x75mm holes in each corner.

The RAM Tough-Claw is the perfect mounting base for quick and easy tool-less installation and removal on round, square, odd shaped rails and bars. The Tough-Claw can be clamped on rails from 0.625"...