Mounting Kits (3,575 items)

Mounting Accessorie

Fits diameter 19-30 mm. Face plate angled 45°. For installation of devices on pipes and stays, for example all kind of vehicles, on motorcycles, boats, carts, stands, wheelchairs, airplanes etc. Th...

Used for installation of a display for Bury CC9060 onto a ProClip Mounting Platform instead of onto a vertical surface. You can adjust the display in order to avoid light reflecion. The cable can p...

Mounting plate (80x50x5mm). AMPS-standard. The choise when you want to install your device positioned a bit to the left or right than the center of the ProClip. Predrilled holes, AMPS standard. Mad...

Extension plate, 155x50x5mm. With predrilled AMPS holes. The extension plate makes it possible to attach two devices onto the same ProClip, e.g. a GPS device holder as well as a mobile phone holder...

Flexible arm, 25 cm. With predrilled AMPS-standard holes. A flexible arm with AMPS plates in both ends. For installation of monitors, printers and other heavier devices in busses, trucks etc. Is to...

ABS-plastic, black. 3 mm. 4 à 80x420, 4 à 120x420, 2 à 160x420, 1 à 200x420. Set with sheets of black ABS-plastic, 3 mm thickness. Allows you to make your own special solutions. Consists of: 4 pcs ...

V-slot button and clip holder. With predrilled holes. Big. Used for mobilephone, pager and orther products with button or a clip-holder. Predrilled for mount on a ProClip.

Vertical Mounting plate (155x50x5mm). The extension plate makes it possible to attach two devices with tilt swivel onto the same ProClip, e.g. a GPS device holder as well as a mobile phone holder. ...

Vertical Mounting plate (155x50x5mm). The extension plate makes it possible to attach two devices onto the same ProClip, e.g. a GPS device holder as well as a mobile phone holder. With predrilled h...

Plate with predrilled AMPS holes. 14x42x50 mm.

Used for positioning the installed equipment further away from the dashboard.

Tilt swivel with face plate for AMPS. Can be angled 20° in every direction. A small, oval face plate with predrilled holes for Brodit holders and THB HF-kits. Can be angled 20° in every direction.

High strength angled mount for a higher placement. With predrilled holes. The choice when you want to install two devices in a higher position, for example to get the device higher up when installi...

High strength angled mount for a higher placement. With predrilled holes. The choice when you want to install fore devices in a higher position, for example to get the device higher up. With predri...