Mounting Kits (3,575 items)

Magnetic mount, 88 mm. With ball that fits with standard duty pedestal ball mount arm, item no 202010, 202011, 202012, 202014, 202015, 202016, 202017, 202018, 202019, 202020. Magnetic mount, 88 mm....

Magnetic mount, 43 mm. With ball that fits with standard duty pedestal ball mount arm, item no 202010, 202011, 202012, 202014, 202015, 202016, 202017, 202018, 202019, 202020. Magnetic mount, 43 mm....

Allows you to move your equipment between vehicles e.g. holder, HF-kit etc, or to easily switch between two units. Comes with adhesive tape on the back, consists of two back pieces and one front pi...

MoveClip Big 2 female + 1 male, 4 screws. 60 x 50 x 5 mm. Allows you to move your equipment between vehicles e.g. holder, HF-kit etc, or to easily switch between two units. Comes with adhesive tape...

Mounting plate angle. 3-pack. Can be used for installation of two devices placed in different height on the same ProClip. (3pcs/pack).

Mounting plate dual, in black ABS plastic (3 pieces/pack) The extension plate makes it possible to attach to units onto the same ProClip, e.g. a PDA holder as well as a mobile phone holder. Comes w...

ABS-plastic, black. 5 mm. 4 à 80x420, 4 à 120x420, 2 à 160x420, 1 à 200x420. Set with sheets of black ABS-plastic, 5 mm thickness. Allows you to make your own special solutions. Consists of: 4 pcs ...

Tilt swivel. With två face plates (parallell center point) The choice when you want to install two units e.g. a holder for a PDA and a HF-kit. With predrilled holes for Nokia and Sony Ericsson Orig...

For GPS remote control Attention! Read all instructions before attaching the ProClip. Peel off both adhesive tape covers on the ProClip. 1. Press the angled edge of the upper part of the ProClip in...

Mounting plate with Tilt Swivel, centered. Low Smaller, lower face plate. The choice for an adjustable monitor angle. Fits monitors with a vertical slot in back.Install onto ProClip.

The extension plate makes it possible to attach to units onto the same ProClip, e.g. a PDA holder as well as a mobile phone holder. Comes with screws and adhesive tape on the back. With predrilled ...

Cover plate to be placed in compartment in the console to the left in Chevrolet Trans Sport 97- .

Adapter plate for LCD-screen without groove in backside, for ProAdapt. The choice when you want to install a monitor without a vertical slot on the back (with a hole underneath for thumb screw atta...

Angled mounting platform, 30°. Attach with adhesive tape to flat, horizontal surface. Attach with adhesive tape onto a flat, horizontal surface. Perfect e.g. for the boat.

Angled mounting platform, 45°. Attach with adhesive tape to flat, horizontal surface. Attach with adhesive tape onto a flat, horizontal surface. Perfect e.g. for the boat.