Mounting Kits (3,575 items)

RAM rubber replacement strap band for EZ-Strap™ mounts.

The RAP-B-201U, composite standard double socket arm, has a socket at both ends that accommodates 1" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball...

MNT-RAM-B202U MNT-RAM-B202U RAM 2.5" Round Ball Base

The RAP-B-379U-252825 consists of a 1" diameter rubber ball, connected to a 1/4"-28 X .25" male threaded post. The male thread matches most standard camera and camcorder female threads found on the...

The RAP-B-379U-252037 consists of a 1" diameter rubber ball, connected to a 1/4"-20 X .375" male threaded post. The male thread matches most standard camera and camcorder female threads found on th...

MultiClip is currently compatible with the following Ingenico payment terminals: Lane/3000 with camera module Lane/3000 Lane/5000 Lane/7000 Lane/8000 Desk/1500 Desk/1600 Desk/1700 AXIUM RX5000 Mult...

The RAP-B-238 consists of a 1" diameter rubber ball connected at right angles to a 2.43" x 1.31" diamond base. The base has two holes 1.912" from center to center, matches the industry standard AMP...

The RAP-395T-BBU consists of a 1" ball, connected to a round base, that contains female grooves and hardware that will allow mounting to all RAM STACK-N-STOW Bait Boards.

Mount an additional device to your 1.5" 2" Torque Rail Base with the RAM B Size Ball Add-On. Use the included hardware to easily attach the add-on to your Torque Rail Base. With an extra B Size Bal...

The RAP-B-379U-311862 consists of a 1" diameter rubber ball, connected to a 5/16"-18 X .625" male threaded post.

The RAM-114FMU contains 4 pre-drilled holes and a socket compatible with RAM ROD and RAM-TUBE holders with a spline post.

The RAP-B-201U-A, short double socket arm, has a socket at both ends that accommodates 1" ball bases. This socket technology allows for almost infinite adjustment and perfect viewing angles. (This ...

Installation Instructions: 1. Locate RAM base to desired mounting location, drill holes with 3/8" drill. 2. Place Mari-Nut™ insert all the way into pre-drilled 3/8" holes until flange is firmly sec...

The Extruded Composite Tough-Track is your cost effective track mounting solution. This version of the Tough-Track does not use end caps and features a tapered end allowing for stress-free insertio...