Industrial PCs (319 items)

Wago 750-404

The counter acquires 24V binary pulses and transports the counter status to the installed bus system. Counting is enabled and inhibited via the GATE input. Digital outputs DO 1 and DO 2 can be set ...

The counter acquires 24V binary pulses over a defined time period (gate time) and transports the counter status to the installed bus system. The U/D input allows either Up or Down counting. Digital...

The counter is used for frequency measurement here, with the pulse period of the 24V signal being measured at the CLOCK input and then converted to a frequency value. Measurement is enabled and inh...

The counter acquires 24V binary pulses and transports the counter status to the installed bus system. The U/D input allows either Up or Down counting. Digital outputs DO 1 and DO 2 can be activated...

The I/O module is equipped with two 16-bit up counters. The CLOCK 1 and CLOCK 2 inputs acquire 24V binary pulses and transmit the counter status to the installed bus system. Digital outputs DO 1 an...

This output module modulates a 16-bit information in the pulse width. The field side is electrically isolated from the bus system. The pulse duty factor is given by a 16-bit value. The outputs are ...

This output module modulates a 16-bit information in the frequency. The field side is electrically isolated from the bus system. The frequency is given by a 10-bit value with a resolution of 2 Hz/d...

After the fieldbus node is assembled with the correct buscoupler and I/O modules, the end module is snapped onto the assembly. It completes the internal data circuit and ensures correct data flow.

The supply module provides the I/O modules with the corresponding supply potential. The maximum current at the supply module is 10A. When configuring the system, it must be ensured that this total ...